Wake On LAN (Remotely power on a computer)

Have you ever wondered how you could power on a computer remotely?

Well, with this program you can do it!

C:\>wol

Wake-On-Lan (WOL) Tool v1.0 by NeoEGM
http://www.neoegm.com/software/wake-on-lan/
-------------------------------------------

Usage: wol 

Wakes the computer with the specified MAC address.

Accepted MAC address formats: 01-4B-8E-00-52-A1
                              01-4b-8e-00-52-a1
                              01:4B:8E:00:52:A1
                              01:4b:8e:00:52:a1
                              014B.8E00.52A1
                              014b.8e00.52a1
                              014b8e0052a1
                              014B8E0052A1

You have to configure the remote computer (the one which will be powered on) to support the Wake-On-LAN feature. This is done in the CMOS settings looking for the “Power/ACPI” settings or something like that.

Then, you have to find out the MAC Address (sometimes called “Physical Address”) of the network adapter connected to the LAN. On Windows it’s done doing this from the console:

C:\>ipconfig /all

Windows IP Configuration

   Host Name . . . . . . . . . . . . : mypc1
   Primary Dns Suffix  . . . . . . . :
   Node Type . . . . . . . . . . . . : Unknown
   IP Routing Enabled. . . . . . . . : No
   WINS Proxy Enabled. . . . . . . . : No

Ethernet adapter Local Area Connection:

   Connection-specific DNS Suffix  . :
   Description . . . . . . . . . . . : Marvell Yukon 88E8056
PCI-E Gigabit Ethernet Controller
   Physical Address. . . . . . . . . : 00-1F-C2-14-B3-F4
   DHCP Enabled. . . . . . . . . . . : No
   IP Address. . . . . . . . . . . . : 192.168.0.1
   Subnet Mask . . . . . . . . . . . : 255.255.255.0
   Default Gateway . . . . . . . . . : 192.168.0.254
   DNS Servers . . . . . . . . . . . : 192.168.0.254

In this case, it’s “00-1F-C2-14-B3-F4″, so the tool can be used like this:

C:\>wol 00-1F-C2-14-B3-F4

Wake-On-Lan (WOL) Tool v1.0 by NeoEGM
http://www.neoegm.com/software/wake-on-lan/
-------------------------------------------

Wake-up packet sent to MAC address 00-1F-C2-14-B3-F4.

There are some restrictions that apply to the hardware, but a summary may be: the motherboard must support the “Wake-On-Lan (WOL)” feature and the NIC (network adapter) must have a wire called with that name connected to the motherboard. If the motherboard of the computer you want to power on is not so old and has an integrated (on-board) Ethernet card, then it’ll probably work.

GNU GPL v3 WakeOnLan is licensed under the GNU GPL v3 (attached)…

Now, the links…

Support appreciated!

All the content offered in this website is, except noted otherwise, of free nature. This means you can share it wherever you want if you do it freely and stating its source.

If it was useful for you and you’d like to contribute, you can make a donation or, at least, visit one of our advertisers of your choice; they are all around the site.

Incoming search terms for the article:



0 Response to “Wake On LAN (Remotely power on a computer)”


Comments are currently closed.